The MagnaFlow # MF15807 is a cat-back system, meaning it connects to the existing exhaust system at the exit of the catalytic converter and extends rear ward to the exhaust pipe.
I've linked you to an FAQ article about Cat-Back exhaust systems. view full answer...
I spoke with my contact at Magnaflow about your 2007 Infiniti G35 Coupe. They told me that the Stainless Steel Cat-Back Exhaust System, part # MF16641 is not much louder than the stock system it replaces. They told me that there is a small change in the pitch but an insignificant change in the noise level. This system is designed to increase horsepower and torque and is constructed of stainless steel.
They also told me that this system weighs quite a lot less than the stock system installed... view full answer...
It is easiest (for me!) to think of engine intakes, exhausts, resonators, etc. as parts of the vehicle "respiratory" system. After all, in a way an engine is simply an air pump; it "inhales" air and "exhales" exhaust. Changing any part of this system will tend to either increase or reduce the engine's ability to mix air and fuel.
Power and torque are a result of air/fuel combustion and a new exhaust for instance that allows the engine to more freely release exhaust can allow better combustion... view full answer...
Yes, you can absolutely switch out the exhaust tips that come with the MagnaFlow Stainless Steel Cat-Back Exhaust System part # MF15750 for your 1998 Chevrolet C/K Series Pickup. The new tips which need to be purchased separately will need to fit a 2-1/2" diameter pipe like the MagnaFlow Exhaust Tip part # MF35210 or part # MF35225 for example.
I have attached a list for you of our exhausts tips that meet the above criteria. view full answer...
The MagnaFlow Pro DPF Series Filter-Back Exhaust System, part # MF17874, has been designed and tested to work with your 2016 Ram 2500 diesel.
Consumers are protected by the Magnuson-Moss warranty act that states in part that unless the part added actually causes a problem then installation and use of the part will not void the warranty view full answer...
What you're experiencing is fairly common but certainly fixable. The exhaust system at the rear of the car is attached to the vehicle using rubber isolators and easily bendable exhaust hangers. Because of this, the actual position of the exhaust system can vary a bit from vehicle to vehicle. When the # 76419 hitch is installed, its position will not vary from vehicle to vehicle. The large tolerances in the exhaust system is what can allow the rattle to occur. In other words, it's not the... view full answer...
For your 2002 Ford F-150 SVT Lightning, the MagnaFlow Cat-Back Exhaust System - Stainless Steel - Gas # MF15714 is the correct fit. It will give you increases of up to 25 HP and up to 30 ft lbs Torque over the stock exhaust system. I've attached a graph to assist. view full answer...
I have included the chart showing the horsepower and torque gains for MagnaFlow exhaust system # MF16864 for the 2006 Toyota Tundra that I got directly from Magnaflow. It is exactly the same between it and # MF15820. So you are looking at up to 9 additional horsepower and 10 feet-pounds of torque.
If it would me I would go with # MF16864 because rear exit dual exhaust is awesome. And it doesn't hurt that it costs a little less. view full answer...
The MagnaFlow Cat-Back Exhaust System # MF19190 is going to be louder than the stock exhaust on your 2017 Jeep Grand Cherokee and I'll send you a link where you can hear what it will sound like when installed on your Jeep. As for performance, the MagnaFlow was designed to improve the amount of horsepower, torque and fuel efficiency; it is far more than a way for your Jeep's muffler to produce a different sound.
The Cat-Back Exhaust System is constructed of 100 percent stainless steel... view full answer...
I contacted our representative at Edge and he informed me that they are getting gains of up to 15 horsepower and 20 ft/lbs of torque added to a stock Ford F-150 using the Edge Evolution CTS2 Programmer, part # EP85450. The gains on your truck could vary slightly.
In addition to a programmer, adding exhaust and an aftermarket intake will also help in performance gains on your 2002 Ford F-150. Adding an intake and exhaust will allow more air to flow to engine and air to flow more freely... view full answer...
The difference between the MagnaFlow Exhaust # MF16676 and # MF15663 is the vehicles they are designed to fit. Part # MF16676 will fit the 2004-2011 Ford Escape w/ 3.0 V6 motor. Part # MF15663 will fit the 2001-2003 Escape w/ 3.0 V6 motor.
If you use part # MF15663 on your Escape, it will not fit properly. You would need to have the exhaust modified to fit.
You should see a slight increase in horsepower, and torque and fuel efficiency. Gas mileage really depends on your driving habits... view full answer...
The exhaust tips are a mainly cosmetic item that won't have much effect on how the exhaust system functions. According to Magnaflow, the # MF35213 will have zero effect on your gas mileage. view full answer...
The MagnaFlow 4-Inch Resonator Exhaust Tip # MF35212 is designed primarily to enhance the exterior appearance of the exhaust. It is not designed to reduce the vehicle interior noise level, which will mostly be related to the type of exhaust installed - a quieter chambered type or a more throaty straight-through type. You might have a loose clamp or a leak somewhere in the system, but a local shop should be easily able to inspect the system and advise if anything is wrong with the installation. view full answer...
According to MagnaFlow, the MagnaFlow Turndown Cat-Back Exhaust System part # MF17108 can provide your 2013 Ram 1500 with the 3.6L V6 engine an increase in horsepower (HP) and torque (TQ) up to 5-7 HP and 5-7 TQ. The system is constructed entirely of stainless steel and comes with 3" diameter tubing. The increased tubing diameter will reduce restrictions and improve engine performance. The system is a custom fit for your truck and is made right here in the U.S.A.
I have attached an install... view full answer...
MagnaFlow describes the sound of cat-back exhaust system # MF15801 as smooth with a deep tone. It is not gravely sounding but more mellow than a resonator type of system that you hear on a lot of import cars. I have included a link to the installation details for you. view full answer...
According to our friends at MagnaFlow, the Stainless Cat-Back System Performance Exhaust System, part # MF15087 will add up to 10 Horsepower and 17 lb-ft of torque. view full answer...
I spoke with my contact at MagnaFlow and the Stainless Steel Cat-Back Exhaust System, # MF16702, will give you a 10 percent increase in horsepower and torque. For your 2010 Dodge Nitro 4.0L you will be looking at a 9 to 15 horsepower increase and an additional 14 ft lbs of torque.
He also told me that they do not measure the level of fuel efficiency for their exhaust systems. Fuel efficiency is more of a by product of this system since it improves your engine performance. There are many... view full answer...
We are not given the decibel level for the systems like part # MF17124 when they are installed. Per the manufacturer, these systems will give your vehicle an aggressive exhaust note while improving engine performance with increased horsepower, torque, and fuel efficiency.
This system is not for use on public roads or highways. These are intended for off-road use only and are not able to be sold in the state of California.
This system is designed for 2011 through 2014 Ford F-150 SuperCab... view full answer...
That's a smart question, though the Air Command Compressor System w/ Light Duty Compressor - Wireless - Smartphone Enabled - Single Path # F2610 does not actually have an air exhaust release because it does not need one. Because it does not actually hold air like an air tank, the compressor does not require an air release.
This compressor is a perfect complement to air bags such as the Firestone Ride-Rite Air Helper Springs - Double Convoluted # F2582 which fit your 2015 Ford F-150. The... view full answer...
You sure can, just Google search 'magnaflow street series Lexus RC sound clip'. You'll be able to hear a clip of what the exhaust sounds like.
The # MF15354 exhaust you referenced is a fit for a 2011-2015 Camaro and therefore wouldn't work on your vehicle. For your 2015 Lexus RC 350, you'd want to use # MF19183. view full answer...
Go To Results